Valves

Drag to rearrange sections
Rich text content

While knife gate valves and gate valves at here share many similarities – they’re both employed in on-off applications, involving slurries along with other viscous media – there are many noteworthy design variances to contemplate when weighing up what sort of valve might be best suited for the job.

 

The flow rate of your globe valve is determined by the space between disc and also the seat. The further apart they may be, a lot more liquid that may flow throughout the valve.Globe valves are designed with a stem coupled to the bonnet right over the disc to take care of a tight seal if the valve is fully closed. Because of that, globe valves are unlikely to experience seat leakage in comparison to other valves.

 

Butterfly valve Stem: The stem with the butterfly valve could be a one-piece shaft or even a two-piece (split-stem) design. The stem generally in most resilient seated designs is protected on the media, thus allowing a simple yet effective selection of material with regards to cost and mechanical properties.

 

Butterfly valve Seat: The seat of your resilient-seat butterfly valve utilises an interference fit relating to the disk edge plus the seat to deliver shutoff. The material with the seat can be achieved from various elastomers or polymers. The seat could be bonded towards the body or it could possibly be pressed or stuck in.

 

Gate valves might be divided into two main types: Parallel and wedge-shaped. The parallel gate valves work with a flat gate between two parallel seats, and also a popular type would be the knife gate valve designed using a sharp edge over the bottom in the gate. The wedge-shaped gate valves use two inclined seats plus a slightly mismatched inclined gate.

rich_text    
Drag to rearrange sections
Rich text content
rich_text    

Page comments